Selectronic Australia Pty Ltd

Selectronic Certified Managed AC Coupling

Selectronic Certified LogoIn 2010 Selectronic developed the now highly acclaimed Managed AC Coupling technology. This technology is suitable for Battery based Solar Hybrid systems and Off Grid systems, as well as Batteryless Solar Hybrid systems requiring export limiting.

By connecting up to five Selectronic Certified grid tie inverters of the same make (either all ABB or all KACO) to the AC Load side (output) of any single phase SP PRO system, it is now possible to utilise efficient high voltage solar arrays that are located remotely from the battery bank.

Selectronic Certified inverters are unique in that they have a RS485 communications link with the SP PRO battery based inverter. This allows precise control of the output from the solar array in up to 0.1% steps, which cannot be achieved with an ordinary generic grid tie inverter and provides superior system flexibility.

Selectronic Certified Grid Tie inverters provide the following:

Battery ready Solar Hybrid system
Zero or Limited export control, with or without batteries
Data capture from grid inverter to SP PRO battery inverter
Maximum battery life via precise charging control
Perfectly suited for Off Grid systems.
No frequency variations to the loads.
Full support from Selectronic

Maintenance, Spares and Repairs

ServicemanWe have a number of service centres to take care of your Selectronic Inverter.
If you have an inverter that needs a little tender loving care, please make contact with one of the centres below.

We understand that many people rely heavily on their inverter so we undertake to carry out any neccessary repairs in the shortest possible time.

My Selectronic or Kaco product needs maintenance or repair!

It is important to determine that the inverter is faulty before returning it for repair so please contact your installer for assistance in diagnosing any system fault. A service fee is chargeable on a functioning inverter regardless of its warranty status.

Please note that all electrical wiring must be carried out by appropriate qualified and licenced personnel. Contact your installer for disconnection and reconnection of your inverter.